Splet11. maj 2024 · Viewed 5k times. 4. Even when memory is fully loaded, the swap file I created is never used. Did I do something wrong ? Output for swapon -s. Filename Type Size Used Priority /file.swap file 15728636 0 -2. Output for cat /etc/fstab. LABEL=cloudimg-rootfs / ext4 defaults,discard 0 0 # Entry for /swapfile /file.swap none swap defaults 0 0. Splet23. feb. 2024 · % man swapon grep -A8 -e '-p' -p, --priority priority Specify the priority of the swap device. pri‐ ority is a value between -1 and 32767. Higher numbers indicate higher priority. See swapon (2) for a full description of swap prior‐ ities. Add pri=value to the option field of /etc/fstab for use with swapon -a.
swapon(8) - Linux man page
Splet14. mar. 2024 · # man swapon -p, --priority priority Specify the priority of the swap device. priority is a value between -1 and 32767. Higher numbers indicate higher priority. See swapon (2) for a full description of swap priorities. Add pri=value to the option field of /etc/fstab for use with swapon -a. When no priority is defined, it defaults to -1. SpletPRIORITY Each swap area has a priority, either high or low. The default priority is low. Within the low-priority areas, newer areas are even lower priority than older areas. All priorities set with swapflags are high-priority, higher than default. They may have any non-negative value chosen by the caller. Higher numbers mean higher priority. apsi has
swapon(8) — Arch manual pages
Splet13. mar. 2024 · 时间:2024-03-13 10:28:39 浏览:0. 可以使用以下命令创建两个交换分区并设置优先级:. sudo fallocate -l 2G /swapfile1 sudo chmod 600 /swapfile1 sudo mkswap /swapfile1 sudo swapon /swapfile1. sudo fallocate -l 2G /swapfile2 sudo chmod 600 /swapfile2 sudo mkswap /swapfile2 sudo swapon /swapfile2. sudo swapon --priority ... Splet-L label Use the partition that has the specified label. (For this, access to /proc/partitions is needed.) -p, --priority priority Specify the priority of the swap device. priority is a value between 0 and 32767. Higher numbers indicate higher priority. See swapon (2) for a full description of swap priorities. SpletThe swapon command is used to activate a swap partition in a specified device. The swapoff command is used to deactivate the swap space on a device. ... Specify a priority for the swap area. Higher priority areas will be used up before lower priority areas are used. # swapon -p 5 /var/tmp/swapfile. 5. Print swap usage summaries, then exit. ap si paper 2 key